Clock. Speedo. X11. Universal. 12v. Programmable

Speedo kit any fitment program to any wheel size for a accurate reading

Our latest kit is now east to install to any bike:

• Speedo MPH or KPH at the press of a button
• Odometer that you can set to you previous Speedo reading
• Trip mode
• Clock 24 hr
• Blue back lighting
• High beam warning light
• Indicator L/H R/H warning
• Neutral light
• Wheel pick up and prox sender 10mm
• Body size Width 98mm height 78mm Depth 48mm mounting hole centres 118mm

You need a 12v feed to power the unit and to fix on the pick up and magnet on the disc or wheel.

We tested one up to 140 mph!!

Wiring information:

• Black/white Earth –
• Light green R/H indicator warning light
• Black L/H indicator warning light
• Orange 12V + feed from ignition switch
• Blue neutral light
• Yellow high beam warning light
• Red permanent feed + from battery
• Grey back ground light + from light switch

Set the magnet on the brake disc or on the rim between 3mm and 10mm apart.

How to program

Mark the wheel with a mark and the floor at the bottom “6 o’clock”, wheel the bike forwards until the mark on the wheel is back at 6 o’clock and mark the floor, then measure the distance between the marks in millimeters (mm).

Lets say its 1535mm then x by 2; (is 3070mm)

Switch on the clocks and follow the list:

• Hold the set button on back of clocks until display flashes 3 sec normally.

• Choose MPH or KPH. Press 'Select' to change.

• Press 'Mode'. Key in the distance 3070mm using the 'Select' button. Use the 'Mode' button to move along.

• The next window with 000000 you can program in the old odometer reading or just press mode to move out

• Last setting. Set clock. Press 'Mode' when finished to exit.

PLEASE NOTE

This is not a plug and play system. It  will need hard wiring in.